|
|
Product Description
Turbo-Seal U is a cold applied, single component, highly elastomeric
polymer rubber infused with special adhesives. Turbo-Seal U is used
to repair water leaks in below grade structures. Due to its superior
flexibility, adhesiveness, and self healing characteristics, Turbo-Seal
U is ideally suited for repairing and restoring damaged waterproofing
membrane systems.
Application
- Underground Garages
- Septic Tanks
- Concrete Reinforced Levies
- Subway Tunnels
- Shrinkage Cracks
- Moving Joints
- Pipe Penetrations
- Rotor Stator Pump
- Injection Packers
- Self healing under hydrostatic pressure.
- Adhesive to wet substrate and heterogeneous surfaces. No primer
necessary. Can be applied to green concrete.
- Absorbs shocks, vibration, and continuous movement with no loss
of adhesion or separation.
- One component. No mixing of chemicals, easy to apply, safe, easily
stored, and transportable.
- High solids content, non-toxic, environmentally friendly. Helps
with LEED qualifications. Easy to install.
- Durable. Chemically resistant, resistant to freeze/thaw cycling.
Effective in many different types of environments.
Test Results
Test Methods : ASTM D56, ASTM D2196, ASTM D2202, ASTM D1353, CGSB
37.50-M89
|
Property |
Results |
Test
Methods |
|
|
Rating
of 1 (Excellent)
|
CGSB
37.50 - M89 |
Flash
Point |
No
observable flash point |
ASTM
D56 |
Viscosity |
3,600,000
CPS @ 72 F |
ASTM
D2196 |
Flow |
113
± 4 mm |
ASTM
D2202 |
Solids
Content |
75% |
ASTM
D1353 |
Directions
- Check the thickness of the concrete. Drill 5/8” diameter holes
to the waterproofing layer at 3.25’ intervals.
- Install the injection packers. For most applications, an injection
pipe with an outer diameter of 5/8” and a packer are used to make
an injection opening and inspection holes at 3.25’ intervals.
- Injection
- Inject Turbo-Seal U slowly at low pressure and continue injecting
until counter flow from other drilled holes is seen. Remove the
injection pipe from the drilled hole that Turbo-Seal U has counter
flowed through. Fill the hole with non-woven cloth and polymer mortar.
If multiple locations have been drilled, repeat process as necessary.
- Some applications may require an initial application of polyurethane
or other material to fill excessive voids.
- Keep the workplace clean.
- Avoid contact with skin and eyes.
- Wear suitable gloves and safety glasses
- Store in unopened containers in clean, dry conditions at 40۫
F to 80۫ F.
- In the event any discrepancies between the specification and
work environment, consult the manufacturer or designer before application.
|
